Bosch Rexroth HM 20-2X/100-H-K35 electronic pressure transducer

HM 20-2X/100-H-K35, manufacturer material number R901342025, is a Bosch Rexroth HM20 electronic pressure transducer with a 100 bar measurement-range class, male G1/4 process connection and three-wire 0.1–10 V voltage output. It converts hydraulic pressure into an analog electrical signal.

The supply range is 18–36 V DC, limited to 30 V DC for cULus applications. The voltage-output load must be greater than 2 kΩ. The stated full-span characteristic-curve deviation includes non-linearity, hysteresis and zero/end-value deviations. Electrical supply, medium compatibility and protection against hydraulic pressure peaks must be checked for the installation. The published historical manufacturer identity omits the N suffix, while later seller labels can differ for the same material number. Confirm the actual delivered throttle execution; no throttle configuration is inferred from that omission.

The selected manufacturer technical reference is RE30272, edition 2018-04. Its separate overload reference is 200 bar and burst reference is 400 bar. Neither value is a permissible continuous measurement range.

The electrical mating connector and any optional cable or mounting accessories must be selected separately; their illustration does not establish inclusion with this article. Representative manufacturer HM20 family photograph; the selected pressure range and process-connection execution are identified by the factory model.