Oleodinamica Marchesini V0810 VUBA 1 hose burst cartridge valve

Oleodinamica Marchesini V0810 is the VUBA 1 hose burst cartridge valve, with factory maximum flow 180 l/min, maximum operating pressure 350 bar and mass 0.098 kg.

This is the bare burnished-steel cartridge for installation in the correctly machined 1" BSP port. The drawing gives cartridge dimension L of 20 mm, dimension L1 of 40 mm, plate-gap reference S of 2.8 mm and required clearance diameter F of 30.5 mm. It is distinct from the complete MFF or MMF housing assemblies.

Install V towards supply and C towards the actuator. If actuator outflow exceeds the adjusted reaction flow, the valve closes to limit uncontrolled descent after hose failure. The manufacturer states that this device is neither a load-holding check valve nor a one-way flow restrictor and recommends a downstream flow-control valve.

The manufacturer recommends a reaction-flow setting of about 1.5 times the system flow. The listed maximum flow and drawing gap S are separate references, not a verified delivered calibration. Hole-on-plate and preset options apply only to separately specified articles and are not inferred for this model.

The local technical PDF retains the complete applicable original manufacturer spread. Neighbouring sizes and optional configurations apply only where explicitly identified. Any 50 °C oil temperature and 30 cSt viscosity shown with curves are reference conditions rather than independent operating limits.