Danfoss OMV HD EM 500 11136765 orbital hydraulic motor

Danfoss OMV HD EM 500, part number 11136765, is an orbital hydraulic motor. The exact article is listed in the current manufacturer catalogue and is explicitly associated with the original dimensional drawing supplied in the local PDF. The nominal size 500 is a series designation; the drawing does not independently establish an exact geometric displacement.

The execution uses a cylindrical keyed shaft with a nominal diameter of 50 mm. The drawing defines the shaft end and mating interface. Mounting tolerances and the part-number-specific reference lengths are retained on the complete original drawing.

Main port connection: 1" BSP. Drain connection: 1/4" BSP. The exact drawing is the reference for thread depth, sealing arrangement and port position. BSP parallel connections and UN/UNF O-ring boss connections are different interfaces and require the corresponding mating fittings.

The factory drawing specifies a cover prepared for a speed sensor and explicitly states that the speed sensor is not included. The factory article name is retained, but this motor is not presented as an assembled sensor package. Confirm the separately required sensor before installation.

The local PDF is an exact article dimensional reference. It does not establish continuous, intermittent or peak operating-pressure, torque or flow ratings for this execution. Select the operating point from the applicable manufacturer performance information; no ratings from a neighbouring execution are inferred here.

Representative Danfoss OMV series photograph supplied on this article’s manufacturer page; shaft, ports, mounting, sensor arrangement and displacement may differ. Use the exact factory-bound dimensional drawing for this article.